Brush Holder (52/54) For Tccs0185
R 39.79
Sign up to be the first to know when it's back in stock.
R 39.79
R 39.79
Product description
Tork Craft Brush Holder (52/54) Service Kit (TCCS0185-SK13)
At a Glance: Replacement brush holder components (parts 52 & 54) for the Tork Craft TCCS0185 cut-off saw
Carbon brushes can only do their job properly if the brush holders keep them aligned, secure and making consistent contact with the spinning armature. When holders crack, loosen, or the seating action becomes unreliable, you may get intermittent power, cutting out under load, or excessive sparking that rapidly wears the commutator. The Tork Craft TCCS0185-SK13 Brush Holder Service Kit replaces the components referenced as parts 52 and 54, helping restore stable brush alignment and dependable electrical contact so your TCCS0185 motor runs smoother and more reliably.
Designed for the Tork Craft TCCS0185 platform, this kit is ideal during motor servicing or when replacing brushes alone doesn’t solve intermittent running. Fit the correct holders, clean out carbon dust, and the saw often goes from “temperamental” back to “trustworthy”.
Features
Features
- Brush support component kit: Replaces the brush holder components that guide and support the carbon brushes.
- Parts reference match: Covers parts 52 and 54 as per the service diagram references.
- Improves brush seating: Helps maintain correct alignment for proper commutation.
- Model-specific compatibility: Intended for use with the Tork Craft TCCS0185 cut-off saw.
Benefits
- More reliable running: Consistent brush contact helps reduce cutting-out and intermittent power.
- Reduced arcing and wear: Correct alignment can lower excessive sparking and slow commutator wear.
- Better servicing results: Ideal when cracked or loose holders make a simple brush replacement ineffective.
Specifications
Specifications
| Description | Spec |
|---|---|
| Brand | Tork Craft |
| Cat No. | TCCS0185-SK13 |
| Product Type | Spare Part Service Kit |
| Component Group | Brush Holder |
| Parts Reference | 52 & 54 |
| Compatible Tool Model | TCCS0185 |
Extra Info
Extra Information
- Compatibility: Intended for the Tork Craft TCCS0185 cut-off saw series.
- Recommended: Inspect/replace the carbon brushes at the same time if they are near wear limits.
- Check the commutator: Heavy burning, pitting or deep grooves may indicate the armature needs attention.
- Keep it clean: Carbon dust build-up can cause tracking and poor electrical contact — clean carefully during service.
Pro Tip
- After fitting brush holders (and brushes), run the saw no-load for 1–2 minutes to let brushes bed in. Moderate sparking at start-up can be normal; heavy arcing or rapid heating means stop and re-check alignment and wiring.
Safety
Safety
- Wear eye protection and a dust mask when working with carbon dust and internal debris.
- Disconnect power before opening the tool or fitting any spare parts.
- Ensure holders, springs and wiring are seated correctly — misalignment can cause sparking, overheating or motor failure.
- After reassembly, confirm the guard is correctly fitted and the spindle rotates freely before use.
- Perform a brief no-load test in a safe area and stop immediately if you see heavy arcing, smell burning or hear abnormal rubbing.
Authencity Guaranteed
We only sell authentic products from verified brand partners and retail partners.
Recently viewed products
- Choosing a selection results in a full page refresh.
- Opens in a new window.