Brush Holder Set Compl. (39/40/46/47) Service Kit
R 53.36
Sign up to be the first to know when it's back in stock.
R 53.36
R 53.36
Product description
Tork Craft Brush Holder Set Compl. (39/40/46/47) Service Kit (TCAG0115-SK12)
At a Glance: Complete brush holder set (parts 39, 40, 46 & 47) for the Tork Craft TCAG0115 angle grinder
Carbon brushes do the dirty work of delivering current into a spinning armature, but they can only do it properly if the brush holders are secure, aligned, and electrically sound. When brush holders crack, loosen, or their springs and seating points wear out, you’ll often see intermittent power, excessive sparking, cutting-out under load, or a grinder that runs “on and off” like it’s haunted. The Tork Craft TCAG0115-SK12 Brush Holder Set Complete replaces the brush holder component group referenced as parts 39, 40, 46 and 47, helping restore consistent brush contact and stable motor operation on your TCAG0115.
Designed for the Tork Craft TCAG0115 platform, this kit is ideal during motor servicing or after brush-related faults. Fit the correct brush holders, check the brushes and commutator condition, and you’ll often solve those frustrating “random cut-out” problems in one clean repair.
Features
Features
- Complete brush holder assembly: Replaces the brush holder set used to support and guide carbon brushes.
- Parts reference match: Covers parts 39, 40, 46 and 47 as per the service diagram references.
- Improves brush seating: Helps maintain correct pressure and alignment for proper commutation.
- Model-specific compatibility: Intended for use with the Tork Craft TCAG0115 angle grinder.
Benefits
- More reliable power: Consistent brush contact helps reduce cutting-out and intermittent running.
- Reduced arcing and wear: Correct alignment can lower excessive sparking and slow commutator/brush wear.
- Cleaner servicing outcome: Ideal when cracked or loose holders make a brush replacement ineffective.
Specifications
Specifications
| Description | Spec |
|---|---|
| Brand | Tork Craft |
| Cat No. | TCAG0115-SK12 |
| Product Type | Spare Part Service Kit |
| Component Group | Brush Holder Set Complete |
| Parts Reference | 39, 40, 46 & 47 |
| Compatible Tool Model | TCAG0115 |
Extra Info
Extra Information
- Compatibility: Intended for the Tork Craft TCAG0115 angle grinder series.
- Recommended: Inspect/replace the carbon brushes at the same time if they are near wear limits.
- Check the commutator: Heavy burning, pitting or deep grooves may indicate the armature needs attention.
- Keep it clean: Carbon dust build-up can cause tracking and poor electrical contact — clean carefully during service.
Pro Tip
- After fitting new brush holders (and brushes), run the grinder no-load for 1–2 minutes to let the brushes bed in. A smooth, even sound and moderate, consistent sparking at start-up is normal — heavy arcing or rapid heating is a sign to stop and re-check alignment.
Safety
Safety
- Wear eye protection and a dust mask when working with carbon dust and internal debris.
- Disconnect power before opening the tool or fitting any spare parts.
- Ensure springs, holders and wiring are seated correctly — misalignment can cause sparking, overheating or motor failure.
- After reassembly, confirm the spindle rotates freely and the guard is correctly fitted before use.
- Perform a no-load test run in a safe area and stop immediately if you see heavy arcing, smell burning or hear abnormal rubbing.
Authencity Guaranteed
We only sell authentic products from verified brand partners and retail partners.
Recently viewed products
- Choosing a selection results in a full page refresh.
- Opens in a new window.