Ratchet Anvil For Air Ratchet Wrench 3/8'
R 131.10
Sign up to be the first to know when it's back in stock.
R 131.10
R 131.10
Product description
AirCraft Ratchet Anvil for Air Ratchet Wrench 3/8" (AT0015-34) for Model AT0015
At a Glance: OEM-fit ratchet anvil (3/8" square drive output) for the AirCraft AT0015 air ratchet wrench—transfers torque from the ratchet head to your sockets.
The AirCraft AT0015-34 ratchet anvil is the square-drive output component used in the AT0015 3/8" air ratchet wrench. It interfaces with the ratchet yoke/gear mechanism and provides the 3/8" drive that locks into your sockets. If the drive end becomes worn, rounded, develops play, or the ratchet head slips under load, replacing the anvil helps restore positive socket retention, consistent engagement, and dependable torque transfer.
The anvil is the output shaft that your socket grips—good fitment here means less slipping, less wear, and smoother work.
Features
Features
- 3/8" square drive output Provides the working drive interface for sockets.
- OEM-fit replacement Designed to suit the AirCraft AT0015 air ratchet wrench.
- Robust anvil construction Built to handle repeated loading in the ratchet head.
Benefits
- Restores socket fit: Helps prevent rounding and sloppy engagement on the drive end.
- Improves torque transfer: Delivers more consistent drive under load.
- Reduces slippage: Helps eliminate skipping or inconsistent engagement caused by wear.
Specifications
Specifications
| Description | Spec |
|---|---|
| Brand | AirCraft |
| Cat No. | AT0015-34 |
| Product Type | Spare Part – Ratchet Anvil |
| Compatible Tool | AirCraft AT0015 Air Ratchet Wrench |
| Drive Size | 3/8" |
| Function | Output drive; transfers torque from ratchet mechanism to socket |
Extra Info
Extra Information
- Compatibility: AirCraft AT0015 Air Ratchet Wrench 3/8" (spare part code: AT0015-34).
- Typical use: Ratchet head output (3/8" drive) interfacing with the ratchet mechanism and sockets.
- Service note: If the anvil is worn, inspect related head parts (yoke/ratchet housing, washers, bushings, needle bearing, clamp nut) for wear or looseness.
Pro Tip
- After fitting a new anvil, check for smooth rotation and minimal end-play—too much play usually points to worn washers/bushings or an incorrectly seated clamp nut.
Safety
Safety
- Disconnect the air supply and bleed pressure before opening the ratchet head.
- Wear eye protection—small parts and springs can release unexpectedly.
- Keep parts clean and organised to ensure correct reassembly and clearances.
- Test operation at low pressure first to confirm smooth engagement before returning to service.
Authencity Guaranteed
We only sell authentic products from verified brand partners and retail partners.
Recently viewed products
- Choosing a selection results in a full page refresh.
- Opens in a new window.